| content |
 |
This article needs additional citations for verification. Please help improve this article by adding reliable references. Unsourced material may be challenged and removed. (September 2008) |
The o-ring chain is a specialized type of roller chain used in the transmission of mechanical power from one sprocket to another.
Contents |
Construction
The o-ring chain is named for the rubber o-rings built into the metal rollers of every link in this particular type of metal chain. Chain manufacturers began to include this feature in the 1980s as a way to improve lubrication to the links of power transmission chains, a service that is vitally important to extending the working life of chain. The o-rings fit into the gap between the rollers and the links that surround each roller and hold the entire chain together. These rubber fixtures form a barrier that holds factory applied lubricating grease inside of the rollers while still applying sufficient lubrication to the chain body. Further, the rubber o-rings prevent dirt and other contaminants from entering the inside of the chain linkages, where such particles would otherwise cause significant wear.
Applications
O-ring chains are most notably used in motorcycles, one of the most demanding applications for a metal chain. High RPM and heavy loads require bulky chains, but such engineering increases the effect of friction compared to lighter chains. So lubrication plays a vital role here, but the high RPM also make it very difficult to keep lubrication inside and on the chain. Additionally, motorcycle chains are exposed to a large volume of contaminants and particles and must be protected. O-rings, as described above, fit this application perfectly.
Care
Depending on usage and wear, o-ring chains should be maintained differently, but it is generally advisable to follow a few guidelines:
- clean the chains often
- never use gasoline to clean the chains, its solvents damage o-rings
- use kerosene or other light petroleum solvent.
- avoid using stiff brushes - they can damage the o-rings
- add o-ring compatible lubricant
- this ensures the lubricant being applied will make it inside the rubber seals
- do this about every 200 miles - on a motorcycle every other gas-stop will do.
- wax-based lubricants have less 'fling' but may attract more dust and grit
- many high-mileage riders use an automatic chain oiler
- some sources note that the o-rings seal the lubricant inside the chain - however you still need to lubricate the chain-sprocket interface.
- when in doubt, purchase a new chain
- generally the sprockets should be replaced at the same time as the chain.
External links
