IntroductionGeostationary orbits can be achieved only very close to the ring 35,786 km (22,236 mi) directly above the equator. This equates to an orbital velocity of 3.07 km/s (1.91 mi/s) or a period of 1436.06 minutes which equates to almost exactly one earth day or 23.934461223 hours. This makes sense considering that the satellite must be locked to the earth's rotational period in order to have a stationary footprint. This can be calculated and verified here: [1]. In practice this means that all geostationary satellites have to exist on this ring, which poses problems for satellites that will be decommissioned at the end of their service life (e.g. when they run out of thruster fuel). Such satellites will either continue to be used in inclined orbits (where the orbital track appears to follow a figure-of-eight loop centered on the equator) or be raised to a "graveyard" disposal orbit. Technically, a "geostationary" orbit is the special case of a geosynchronous orbit which is circular and in the equatorial plane. In practice, however, the terms geosynchronous and geostationary are mostly used interchangably. Some people in the industry dislike the term "geostationary," because the orbit is not actually stationary (in fact, the term stationary orbit would be an oxymoron), and prefer to use "geosynchronous" because it emphasizes the key point that the orbit is not actually stationary, but synchronized with the motion of the Earth.citation needed A geostationary transfer orbit is used to move a satellite from low Earth orbit (LEO) into a geostationary orbit. A worldwide network of operational geostationary meteorological satellites is used to provide visible and infrared images of Earth's surface and atmosphere. These satellite systems include:
Most commercial communications satellites, broadcast satellites and SBAS satellites operate in geostationary orbits. (Russian television satellites have used elliptical Molniya and Tundra orbits due to the high latitudes of the receiving audience.) The first satellite placed into a geostationary orbit was Syncom-3, launched by a Delta-D rocket in 1964. A statite, a hypothetical satellite that uses a solar sail to modify its orbit, could theoretically hold itself in a "geostationary" orbit with different altitude and/or inclination from the "traditional" equatorial geostationary orbit. Derivation of geostationary altitudeIn any circular orbit, the centripetal acceleration required to maintain the orbit is provided by the gravitational force on the satellite. To calculate the geostationary orbit altitude, one begins with this equivalence, and uses the fact that the orbital period is one sidereal day. By Newton's second law of motion, we can replace the forces F with the mass m of the object multiplied by the acceleration felt by the object due to that force: We note that the mass of the satellite m appears on both sides — geostationary orbit is independent of the mass of the satellite.[1] So calculating the altitude simplifies into calculating the point where the magnitudes of the centripetal acceleration required for orbital motion and the gravitational acceleration provided by Earth's gravity are equal. The centripetal acceleration's magnitude is: where ω is the angular speed, and r is the orbital radius as measured from the Earth's center of mass. The magnitude of the gravitational acceleration is: where M is the mass of Earth, 5.9736 × 1024 kg, and G is the gravitational constant, 6.67428 ± 0.00067 × 10−11 m3 kg−1 s−2. Equating the two accelerations gives: The product GM is known with much greater accuracy than either factor; it is known as the geocentric gravitational constant μ = 398,600.4418 ± 0.0008 km3 s−2: The angular speed ω is found by dividing the angle travelled in one revolution (360° = 2π rad) by the orbital period (the time it takes to make one full revolution: one sidereal day, or 86,164.09054 seconds).[2] This gives: The resulting orbital radius is 42,164 kilometres (26,199 mi). Subtracting the Earth's equatorial radius, 6,378 kilometres (3,963 mi), gives the altitude of 35,786 kilometres (22,236 mi). Orbital speed (how fast the satellite is moving through space) is calculated by multiplying the angular speed by the orbital radius: Practical limitationsWhile a geostationary orbit should hold a satellite in fixed position above the equator, orbital perturbations cause slow but steady drift away from the geostationary location. Satellites correct for these effects with station keeping maneuvers. In the absence of servicing missions, consumption of thruster propellant for station keeping places a limitation on the lifetime of a satellite. CommunicationsSatellites in geostationary orbits are far enough away from Earth that communication latency becomes very high — about a quarter of a second for a one-way trip from a ground based transmitter to a geostationary satellite and back, and close to half a second for round-trip end-to-end communication. For example, for ground stations at latitudes of φ=±45° on the same meridian as the satellite, the one-way delay can be computed by using the cosine rule, given the above derived geostationary orbital radius r, the Earth's radius R and the speed of light c, as This presents problems for latency-sensitive applications such as voice communication or online gaming.[3] Orbit allocationSatellites in geostationary orbit must all occupy a single ring above the equator. The requirement to space these satellites apart means that there are a limited number of orbital "slots" available, thus only a limited number of satellites can be placed in geostationary orbit. This has led to conflict between different countries wishing access to the same orbital slots (countries at the same longitude but differing latitudes). These disputes are addressed through the ITU allocation mechanism.[4] Countries located at the Earth's equator have also asserted their legal claim to control the use of space above their territory.[5] See alsoNotes and references
External links
| | ||||||||||||||||||||||||||||||||||||||||||||